How to Update the AnyTone 878 Plus Firmware to V1.22

How to Update the AnyTone 878 Plus Firmware to V1.22

Have you updated your AnyTone 878 Plus to its newest firmware V1.22? Today’s V1.22 firmware will be improving digipeater paths, key tones, 5 tone decode units, and resolve some CPS errors. The full update is stated below in the description. In this video we’ll be going over how to update the AnyTone 878 Plus radio firmware to V1.22 and from there we’ll program the CPS as well.

AnyTone AT-D878 Plus CPS/Firmware →

Previous article Share Your Shack Giveaway Winner Announcement

Comments

steve smith - September 2, 2021

when I update as you have depicted, my existing channels are not effected? I do not have to reload any?

Roland Massatti - August 27, 2021

Thank you for the video. I was able to update the radio to the latest version. I also downloaded the print version of the Firmware update, but it add other steps to the update, like rebooting the MCU. My radio does not work the way starting with step 9. It follows pretty much the video. Is there anything different to the printed version?
Thanks,
K8WUA

Gary Turner - August 27, 2021

Thank you for posting this. It was a great refresher,
K4BNA – Gary

Dick W1REJ - August 27, 2021

Well done, very clear on instructions to update CPS and firmware.

Ronald George Revelle - August 27, 2021

Thanks. Worked great

Alan Start - August 27, 2021

I understand after watching the 878 Firmware update video how it’s done however how do I get my code plug installed into the new CPS software or does it do that automatically? -Al N3ZJV

Leave a comment

Comments must be approved before appearing

* Required fields